グラフィット銅の袖
High Speed Graphite copper sleeve JDB 5*7*12 Pump truck bushing
High Speed Graphite copper sleeve JDB 5*7*12 Pump truck bushing The JDB5*7*12 bushing answers a simple maintenance problem: pivot points that are hard to reach. Because the solid lubricant is embedded in the brass wall rather than supplied from outside, the bearing keeps working in dusty, wet or ...
High Precision Graphite copper sleeve JDB 5*7*10 Drilling rig bushing
High Precision Graphite copper sleeve JDB 5*7*10 Drilling rig bushing Built around a cast brass matrix with evenly distributed solid graphite plugs, this JDB5*7*10 sleeve keeps a transfer film on the shaft surface, so the joint runs smoothly even when the grease nipple is missed for weeks. Its 7 mm ...
Strict Quality Inspection Graphite copper sleeve JDB 5*7*8 Excavator bushing
Strict Quality Inspection Graphite copper sleeve JDB 5*7*8 Excavator bushing Pressed into a worn housing, the JDB5*7*8 bush restores the original bore size and adds dry-running capability the original part never had. Its 5 mm bore is honed for shaft contact, while chamfered ends ease installation ...
Long Service Life Graphite copper sleeve JDB 4*8*22 Port machinery bushing
Long Service Life Graphite copper sleeve JDB 4*8*22 Port machinery bushing The JDB4*8*22 graphite copper sleeve is turned from high-lead brass and fitted with graphite plugs covering roughly a quarter of the sliding surface. This ratio is enough to keep friction low under boundary lubrication ...
Rust & Corrosion Resistant Graphite copper sleeve JDB 4*8*15 Mining machinery bushing
Rust & Corrosion Resistant Graphite copper sleeve JDB 4*8*15 Mining machinery bushing For Mining machinery maintenance teams the JDB4*8*15 sleeve removes a recurring weekend job. Instead of pulling pins to grease them, fitters press in a new graphite copper sleeve and return the machine to service; ...
OEM Standard Production Graphite copper sleeve JDB 4*8*12 Rubber machinery bushing
OEM Standard Production Graphite copper sleeve JDB 4*8*12 Rubber machinery bushing A brass-graphite composite construction gives the JDB4*8*12 bushing two working modes in one part: it runs dry during start-up and short cycles, and it accepts grease where a lubrication point already exists. That ...
Precious Machined Graphite copper sleeve JDB 4*8*10 Metallurgical equipment bushing
Precious Machined Graphite copper sleeve JDB 4*8*10 Metallurgical equipment bushing Dimensional accuracy matters more than raw hardness in a pivot bush, and the JDB4*8*10 sleeve is finished on CNC centres to hold bore roundness and length tolerance tightly. Graphite columns are set at an angle that ...
Wear Resistant & Durable Graphite copper sleeve JDB 4*8*8 Loader bushing
Wear Resistant & Durable Graphite copper sleeve JDB 4*8*8 Loader bushing This JDB4*8*8 self-lubricating bush was developed for oscillating joints that never complete a full rotation. In such motion the oil film of a plain bronze bush tends to collapse; the graphite inserts here keep replenishing a ...
High Quality Graphite copper sleeve JDB 4*6*12 Crane bushing
High Quality Graphite copper sleeve JDB 4*6*12 Crane bushing With a wall thickness that suits standard reamed housings, the JDB4*6*12 graphite copper sleeve is a direct replacement part for OEM pivot bushings. The graphite plugs sit slightly below the sliding surface, protecting them during assembly ...
